-… .-.. --- --. ..---Blog #2
On the 9th of this month was the 4th running of the Tommy Knocker bicycle race up in Fort Bayard. We had a number of hams handling the communications for the race, and it went quite well. There were 3 race stations (A, B, C) and a Command post. Those hams, in no particular order, were: Jeff W5BOR, Andrea K1ZZE, Glenn W5GJP, John KF5SEA, Rhett KF5TU, Dan N2RDO, Rawlings KI5DIM, Mark KI5DIV, Laurie K5WLO, and Marc, W5MTS. Marc and Laurie split the Command Post duties with Marc being in charge overall. The race began at 8am and those hams at stations A and B had to leave to hike in before the sun quite came up. Those who had the afternoon shifts at those two stations, had to walk out after dark. The riders were nice to deal with and most of them thanked us when they whipped by the stations, thanking us for volunteering. My wife and I have been there 3 year in a row now and quite enjoyed our time there, other than the cold walk before the sun came up. We all used the GARS repeater for the duration of the race.
I was at station B, which is down in a small canyon, and the signal has a hard time getting to the repeater. And that is even with a 15” high gain antenna on my handheld, which is a 5w Yaesu FT-60. So before I went out there last year, I built a 2m J-Pole antenna out of 300 ohm twin lead. The twin lead is the type of wire that used to be used to bring a signal from an outside antenna to your TV, back when they used antennas. It is hard to find now days without ordering on the internet, but I managed to find a friend who had a short length hanging around. On the last net this weekend, I had one of the hams who checked in and asked me about making a portable antenna for just that purpose, so here is what I did a year ago and you can do the same.
On the internet, go to one of the following websites for good directions and pictures. My antenna is from the first web site, but all of them will work well:
For 300 ohm twin lead and complete directions: https://www.qsl.net/wb3gck/jpole.htm
For 450 ohm twin lead, go to:www.w4ava.org/2mjpole.pdf
The above two are for 2m only. However, If you would like to make a j-pole for 144 and 440 MHz, then go to: https://lakelandarc.org/articles/k1du_jpole.htm
I used 300 ohm twin lead, about 20 feet of RG 58U, which can be had locally at Sierra Communications downtown, a PL 259 uhf connector, and a short piece of coax with a fitting on one end to attach to your radio and the other end has a SO 239. I also bought at Walmart, a small roll (150 yds) of .029” Zebco 50# fishing line. In addition, I found in my junk box a ½” nut. I tied the nut onto one end of about 25 feet of fishing line and then threaded the line through a small hole I punched with an awl and tied a knot. I threw the nut up over a tree branch about 12-15 feet up and pulled the j-pole up in the air. The bottom of the antenna was only about 6 feet high. I then hooked the whole mess up to the radio and worked the Tommy Knocker bicycle Race.
The whole antenna and its parts roll gently into a sandwich bag and sit there until I need it again.
-… .-.. --- --. .----
The Gila Amateur Radio Club is inaugurating a Blog, beginning this month. I expect that there will be a new one, perhaps every month. It will consist of club news, events (past and future) and other happenings of interest to all hams. Perhaps some will even have hands-on tips/help for using your equipment. I’m not sure what will be here, but there should be something of interest to everyone at one time or another. You will only have to tune into this website and see what is currently here. You will also be able to read past blogs that you may have missed. If you would like some information on some subject or have an announcement, send a message to the email address on the front page of this website, and let us know. If you would like to write a blog, also let us know.
On February 2, 2019, GARS had their first quarterly meeting of the year . It was held in the City Hall Annex on Hudson Street next to the Washington Bank. Elections were held and the following officers were elected:
Russ Imler K2RSI President
Glenn Persons W5GJP Vice Pres
Andrea Imler K1ZZE Sec/Treas
Bob King WA0QJE Communications
In addition: Stan Gantz W5GZ was appointed as the Repeater Trustee, and Marc Levesque W5MTS was appointed as head of repeater maintenance.
Last Saturday, February 9, was the last class for new prospective hams wanting to become licensed. It was held downtown at the City Hall Annex on Hudson Street and met 4 out of the last 5 Saturdays from 9am to 1pm. There were 13 students who were expertly taught by Andrea Imler K1ZZE. The class was sponsored by SAR in conjunction with GARS. Some of the students were involved with SAR and others were just eager to get their ham license. The last class was missing 3 people due to work responsibilities, and they will take their tests later. Two others wanted to wait for a couple of weeks, so we will reschedule them for later also. However, testing was given at the end of this class and 8 people took the test, with 7 of them passing. That is good for Search and Rescue and also for our club. Congratulations to them all. They should get their Call Signs in a week or so. The testing VEs were Steve London N2IC, Bob King WA0QJE, Glenn Persons W5GJP, and Marc Levesque W5MTS.
The GARS net is still running and we are slowly getting more participation. Times are Sunday and Thursday nights at 8pm on the GARS Repeater at 146.980, with a PL of 103.5. Any licensed ham can come and join in the fun. I hope to have a listing of who has been visiting us on the net in the future. Some of the hams new to the net in the last month are Jeffery Johnson K5BOR, and Steven Budny KC1ACL. Steven has just moved here from Rhode Island. Bob Deal K5PPP and Verna Deal N5PPP have moved back to their home here from Las Cruces. We welcome them back. Join us on the net sometime; we’d like to hear from you.